Steel Stud Wall Stucco
Steel Stud Wall Stucco
XPS CI with Taped XPS Joints AWB
Overview
Overview
This Enclosure Solutions Wall System includes a steel stud structure with stucco, exterior gypsum sheathing, XPS continuous insulation with taped joints & fiberglass cavity batt insulation. Complies with NFPA 285 (fire), ASTM E2357 (air), & ASTM E331 (water).
Get all the construction documentation you'll need, in a single click:
Specifications and Literature
Specifications and Literature
undefined (1)
undefined (5)
undefined (5)
undefined (1)
Products In This Solution
Products In This Solution
Additional Products
Additional Products
Sold Separately
- Interior Gypsum Board
- Galvanized Steel Studs
- Exterior Gypsum Sheathing
- Air & Water Sealing Fasteners
- Lath Drainage Plane
- Lath Screws & Washers
- Stucco System
Performance Attributes
Performance Attributes
Durability
Easy Installation
Recycled Materials
Thermal Comfort
ASHRAE 90.1
ASHRAE 90.1
ASHRAE Standard 90.1 requires Continuous Insulation (CI) be used for all commercial and some residential buildings in the United States. Continuous insulation is defined in 90.1 as “insulation that is continuous across all structural members without thermal bridges other than fasteners and service openings. It is installed on the interior, exterior, or is integral to any opaque surface of the building envelope”.
ASTM E2307
ASTM E2307
ASTM E2307 measures the ability of perimeter fire barrier systems to maintain a seal and prevent interior fire spread as the exterior wall assembly deflects and deforms during fire exposure. The ASTM E2307 test exposes the joint to fire from the room of fire origin and the exterior wall to fire from both the interior and the exterior as the fire plume exits the room of fire origin through a window opening. ASTM E 2307 determines the period of time that the perimeter fire containment system will limit flame penetration through the opening between the exterior wall assembly and the floor assembly.
NFPA 285 Compliant
NFPA 285 Compliant
NFPA 285 is required in the International Building Code (IBC) in multiple situations. The NFPA 285 test is to determine that combustibles, when exposed to fire on the exterior face of the wall, do not spread flame over the surface or through the core of the otherwise non-combustible wall assembly.
Additional Attributes and Compliance
Additional Attributes and Compliance
This wall assembly enclosure also meets the following codes and standards. Click a standard to learn more
Case Studies & Projects
Case Studies & Projects
Owens Corning® Enclosure Solutions deliver buildings that perform without compromising design. Take a look at a few key case studies below.
Toledo, OH
Owens Corning contributed science expertise and donate a range of insulation products including FOAMULAR® XPS insulation which was used in the building's enclosure.
Asheville, NC
Mission My Care Plus Leicester, used FOAMULAR® 250 Continuous Insulation and JoinstSealR® Foam Joint Tape in the construction of the three-story Medical Office Building.
Kent, OH
Kent State College of Architecture represents bold, contemporary building design. Easy-to-install FOAMULAR® 250 Continuous Insulation was incorporated in the Building Enclosure.
Contact Us
Contact Us
Even though we’re a global company, we’re always ready to answer your technical support questions regarding our products and solutions. Email to speak with our GETTECH team.